MKS base 1.4

MKS Base V1.4 board:

 

This is the combination of Arduino MEGA2560 + RAMPS1.4 + 5 x A4988 drivers (remix board)

Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware

Firmware can use the same configuration as RAMPS1.4

It is suitable for dual-Extrude printer

Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board

3x temperature ADC connectors for thermistors

Up to 5 motor drivers with A4988

4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans)

4 layers PCB, optimize heat dissipation.

6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax

Recoverable fuse for short-circuit protection.

USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip

53,00 €

  • 0,1 kg
  • Uitverkocht